Suggestions please

[86starion]

Wat up nyce1s people need some help.
I have a 94 coupe with ls.
I also have a set of ctr piston I want to put in it
but I want to run with the ls head
wat I want to k ow wats the max I can mill the head
with out messing up the stock head.
And also wat r a good set of cams to run this combo with

All suggestions welcome cuz I have no idea WTF I'm doing
right know never had a Honda befor

[Devin]

you also have no idea were to make a thread......... lol

[C Nyce]

.005 is the most you will want to mill the stock head, crower makes good ls cams. what gas will you be using, ctr pistons will have your compression up there..

[Bigjosh]

When doubt leave it out . Call Marco at Westchester Crank and say bigjosh sent you then after that call Wayne Speed and i will see you in the 8s son as simple as that.

[86starion]

I will be using 93 and I want to use c16 at the track if possible but I don't want to go with a full stand alone will a piggy back be enuff siNce it will mostly be used on the street

[vtecb18c]

any specific reason your using an ls? or is it just cause you have it?

[86starion]

Just cause I have it when I boughtthe car it had an lsvtec
but the car was stolen so I just started over with wAt I have
for now

[C Nyce]

no need for c16 that will be over kill, 100oct will do!

[Victor@F&H]

When doubt leave it out . Call Marco at Westchester Crank and say bigjosh sent you then after that call Wayne Speed and i will see you in the 8s son as simple as that.

Wow :confused:

[86starion]

Would h22 injectors be good for this setup
or should I go with aftermarket